正規品を、安心して選べる。半導体・電子部品の通販サイト
Menu
English
SELECT YOUR LANGUAGE
RMB
SELECT YOUR CURRENCY FOR DISPLAY
優遇ステージ/割引率について

現在の商品表示価格は下記が適用されています。


・お客様のご利用状況によって優遇ステージと割引率が適用されます。
・割引に関しましては当WEBサイトからの直接のご注文に限ります。
・一部優遇ステージ対象割引にならない製品や数量がございます。
・優遇ステージの詳細はお客様担当へご確認ください。
・その他の割引とは併用できません。

News Center

Microchip's new Smart Hub with FlexConnect broadens application space of USB3.0 Hubs

2015/07/24Microchip Technology  Network/Telecommunication

 

Microchip’s USB5734 Smart hub is a 4 port, SuperSpeed (SS)/Hi-Speed (HS), low power, configurable and fully compliant with the USB 3.1 Gen 1 specification. The USB5734 also supports Full Speed (FS) and Low Speed (LS) USB signaling, offering complete coverage of all defined USB operating speeds. The new SuperSpeed hubs operate in parallel with the USB 2.0 controller, so 5 Gbps SuperSpeed data transfers are not affected by slower USB 2.0 traffic.


The USB5734 is also a Smart Hub which is defined as a USB hub that integrates system levels functions typically associated with a separate MCU or processor. Microchip’s USB5734 Smart Hub enables communication to other peripherals in addition to USB. This I/O bridging capability allows the host to seamlessly interface to peripherals via I2C, SPI, GPIOs or a UART over USB. Microchip’s Smart hubs also enable a downstream device to take control of the host system by swapping roles and becoming the host port. The Smart hub can also switch between two different hosts if required. This role changing technology is called FlexConnect and can be initiated through hardware or software commands.


Smart hubs also supports custom configurations of external ports and GPIO pins. ProTouch2, Microchip’s proprietary software utility, can be used to program On-chip One Time Programmable (OTP) ROM which stores required register settings to ensure the desired start up configuration at power on. All LED, GPIOs and port control signal pins are under firmware control, allowing for maximum operational flexibility. However, for even more simplicity, the USB5734 can be configured through a series of external low-cost resistor bootstraps. A handful of bootstap pins are available on the USB5734 to enable standard configurations for GPIOs and downstream ports. No OTP programming required..


*The USBCheck online design review service is subject to Microchip's Program Terms and Conditions and requires a myMicrochip account.


Visit Chip1Stop Chinese site
Visit Chip1Stop Korean site
Visit Chip1Stop English site
Visit Chip1Stop German site











Companies Website:
http://www.microchip.com/

Microchip Technology News Release

Related News Release